15 Meter C/52- Construction and Industrial Hose

15 Meter C/52- CONSTRUCTION AND INDUSTRIAL HOSE

Length: 15 m
Color: outside white
Material: Outside: Polyester yarn, round woven, chain 2-ply twisted
Operating pressure: 10 bar

• with Storz suction couplings
• Wire binding
• uncoated
• Protective sleeve to prevent chafing at the hose coupling

User Information:
This manual should be read carefully before first use and followed during use.

1. General Information on Flat or Pressure Hoses
Pressure hoses primarily serve the purpose of liquid transfer, especially water.
However, they can also be used for draining wastewater or similar. They are made of round-woven synthetic fibers (in this case polyester) and are coated on the inside.
A significant advantage of flat hoses is their low weight and flexibility, which makes them easy to fold and transport when not under pressure.

2. During Use
Due to their primary purpose and predominant areas of use, flat hoses are subject to high external influences that can shorten their lifespan.
For optimal usage duration, the following is recommended:

• Do not exceed the maximum operating pressure.
• When laying out the hoses, ensure they are rolled out if possible. Otherwise, always pull them flat. This can prevent the hose from dragging on the edge on the ground and immediately damaging the hose cover.
• Avoid rough surfaces if possible.
• Do not drag hoses over sharp, pointed objects and/or surfaces.
• Never drop hose ends or fittings, as this can lead to damage to the lugs or the fittings themselves.
• Do not pull or drag hoses under pressure on the ground, as the resulting abrasion can damage the hose cover. Vibrations of hoses under pressure can be reduced or absorbed using accessories, such as burlap, tarps, or bandages.
• If hoses are to be used at transitions, hose bridges should be used. Hoses should never be driven over or stepped on.
• Keep hoses away from acids, chemicals, and hazardous substances if possible.

3. After Use
To ensure the longevity of the hoses, the following instructions should be observed after use:

• To remove the remaining liquid medium from the hose, the hose should be lifted over the shoulder. Never step on the hose!
• After use, clean hoses from deposits inside the hose (sand, etc.), i.e., rinse them out. They should then be dried (otherwise mold/lime can deposit inside the hose, which can permanently damage the core).
• Clean the hose cover from external dirt.
• Hoses should never be stored in a damp condition.
• Check fittings for integrity.
• Store hoses in a rolled-up condition if possible.
• When rolling up, ensure that the hoses do not drag on rough surfaces, as when unrolling.